Jib Crane Safety

 

Jib Crane Safety




Jib Crane Safety - Do's

ü  Operator must check the hoisting equipment and jib crane daily before operation. 

ü  Do be familiar with operating controls, procedures, and warnings on the unit. 

ü  Do make sure hook travel is in the same direction as shown on controls. 

ü  Do make sure hoist limit switches function properly. 

ü  Do maintain firm footing when operating hoist. 

ü  Do make sure that load slings or other approved single attachments are properly sized and seated in the hook saddle. 


What is Work At Height | Height Work Safety




ü  Do make sure the hook latches, if used, are closed and not supporting any part of the load. 

ü  Do make sure that the load is free to move and will clear all obstructions. 

ü  Do take up slack carefully, check the load balance, move the load a few inches, and check load holding action before continuing. 

ü  Do avoid swinging of load or load hook. 

ü  Do make sure that all persons stay clear of the suspended load. 

ü  Do warn personnel of an approaching load. 

ü  Do protect wire rope and load chain from weld spatter or other damaging contaminants. 


OIL SPILL RESPONSE & PREVENTION


ü  Do promptly report any malfunction, unusual performance, or damage of the unit. 

ü  Do inspect unit regularly, replace damaged or worn parts, and keep appropriate records of maintenance. 

ü  Do use the hoist Manufacturer’s recommended parts when repairing unit. 

ü  Do use hook latches wherever possible. 

ü  Do apply lubricant to the wire rope or load chain as recommended by the Hoist Manufacturer.

 

 Hand Drill Machine Inspection Checklist - 

English & Hindi

 

Jib Crane Safety - Dont's

Ø  Do Not lift more than the rated load. 

Ø  Do Not use hoist load limiting device to measure the load. 

Ø  Do Not use damaged hoist or hoist that is not working correctly. 

Ø  Do Not use hoist with twisted, kinked, damaged, or worn wire rope or chain. 

Ø  Do Not lift a load unless wire rope is properly seated in its groove(s) or unless chain is properly seated in chain wheel(s) or sprocket(s). 

Ø  Do Not use load rope or load chain as a sling or wrap load rope or load chain around the load. 

Ø  Do Not lift a load if any binding prevents equal loading on all supporting ropes and chains. 


Rigging & Lifting Safety Training (Pictorial) – Part 2



Excavation Hazards & Control


Ø  Do Not apply the load to the tip of the hook. 

Ø  Do Not operate unless load is centered under the hoist. 

Ø  Do Not allow your attention to be diverted from operating the hoist. 

Ø  Do Not operate hoist beyond limits of load rope or load chain travel. 

Ø  Do Not use limit switches as routine operating stops unless recommended. They are emergency devices only.

Ø  Do Not use hoist to lift, support, or transport people. 

Ø  Do Not lift loads over people. 

Ø  Do Not leave a suspended load unattended unless specific precautions have been taken. 


Part 3 - ADNOC & GULF HSE Interview 

Questions & Answer


Ø  Do Not allow sharp contact between two hoists or between hoist and obstructions. 

Ø  Do Not allow the wire rope, chain, or hook to be used as a ground for welding. 

Ø  Do Not allow the wire rope, chain, or hook to be touched by a live welding electrode. 

Ø  Do Not remove or obstruct the warnings on the hoist. 

Ø  Do Not adjust or repair a hoist unless qualified to perform hoist maintenance. 

Ø  Do Not attempt to lengthen the load rope or chain or repair damaged load rope or chain.


Concrete Pump Car Pictorial Safety Checklist




No comments:

Post a Comment