Forklift Pre Start Checklist
Forklift Pre Start Checklist
• Pre start
checklist is to be completed every day prior to using the equipment. Operator is to initial when
inspected, Supervisor is to review the
checklist and sign off at the end of each week.
• Seat Belts to
be worn where fitted.
Forklift Type............................................................ Forklift
Number.......................................................................
Date (Week Commencing
Mon).............................
M T W T F S S
Initials of person doing inspection
Tick if item is acceptable, cross if it is not
TYRES – check they are in good condition,
intact with rim. Look for visual
wear or damage. Check tyre pressure
FLUIDS – check oil, hydraulics, battery, fuel
and coolant for leaks including
hoses under fork lift
STRUCTURE –
check for cracks, bends, dents, distortion or broken parts.
Check apron & overhead guards are intact
& secure
TINES/FORKS – check they are evenly spread
with locking pins in place.
Check there is no sharp edges or distortion
MAST –
check chains are level with no obstructions, rams not pitted or
leaking.
Check for any wear to lift chains and guides, inspect hydraulic
cylinders, look for any leaks
BATTERY – check it is operational and for any
damage
BATTERY CHARGE – discharge meter in full green
or 75% after raising forks
(where applicable)
GAS OPERATED FORKS – check gas levels are ok
and gas cylinder is not
damaged damage. Check gas cylinder is secure
ENGINE BAY –
check it is generally clean?
Hydraulic oil-brake pads and brake fluid (cb
machines only).
CONTROLS (pre start) – check seat
condition. Check controls are clearly
marked, seat & steering wheel are secure
& properly adjusted. Seat belt
(where fitted) works as intended.
CONTROLS (post start) – check controls and
pedals are working. No unusual
noises.
CAPACITY/LOAD PLATE – check load-capacity
plate if fitted, legible and
correct.
What is your safe working load (inc when travelling, tilted &
lifting)?
REVERSE BUZZER & HORN – check working
LIGHTS & BEACON – check working
STEERING – check smooth from lock to lock, no
binding
BRAKES – check both brake & park brake for
proper operation
SAFTEY PEDAL
– check the motor cuts out
POWER DISCONNECT – check all electric power cuts out
HYDRAULICS –
Operate lift, tilt & reach to full extent of travel
GUARDS – check overhead, load backrest
ATTACHMENTS – check they function correctly,
no unusual noises
If any items above are not working, the
forklift is to be tagged out and reported to the supervisor for repair.
Description of
Issue………………………………………………………………………………………………………………
Date and time tagged out:….…………………… Tagged out
by:…………………….. Returned To Service:………….
Weekly Supervisor sign off………………………………………………….
